Key-driven CNC machined billet aluminum ATV axle assemblies offer superior strength without the added weight. Where a conventional ATV axle uses splines, this axle uses a key drive. Each hub has been split and is clamped on the axle shaft with a set of pinch bolts. This key drive and "pinched" hub are similar to that used on Shifter Carts and Jr. Dragsters. This configuration in an ATV axle has proven itself to be a bullet-proof and maintenance-free design for recreational dune riding, hill shooting, and drag racing. 7075-T6 axle shafts are 40mm diameter from end-to-end. Our wheel hubs can be adjusted to set the desired tracking width.
Available in 3 different sizes 26" DRAG axle is Gun-Drilled the entire length with a 19mm hole. 30" HILLSHOOTER axle is Gun-Drilled the entire length with a 19mm hole. 34" PLAY axle is solid. 100% USA materials and labor. This 26" long Banshee Gun-Drilled Drag Axle assembly weighs under 10 lbs!
Axles available for TRX250R, TRX400EX, TRX450R, Banshee, 660 Raptor, 2004/2005 YFZ450, 2006-2008 YFZ450, YFZ450R, 700 Raptor and LTR45
These are the pivot bearings for the front of the Swingarm. You will need to reuse your seals and inner sleeves. Sold to replace only the bearings in one Swingarm.
TIP: freeze bearings 24 hours before installing them and they will go in easily.
TERMS: Any warranties of product we sell should be taken up with the manufacturer. Prices are subject to change without notice. By submitting your order form you declare that TerraFab and its affiliates are not responsible for any injury, loss, or damage due to the use of its products or services.
520 EXTENDED HEAVY DUTY ATV CHAIN
520 EXTENDED HEAVY DUTY ATV CHAIN
Quality engineered for strength and durability
All chains are pre-stretched and shot-peened
Precision tolerances for perfect balance in every pitch
Complete with oiling hole in the bushing to insure proper lubrication
Tensile strength 6600 lbs.
NOTE:Non o'ring chains make 1-2 more H.P. at the rear wheel compared to an o'ring chain because they have less drag . This is why most use non o'ring chains.
TM DESIGNS REAR CHAIN GUIDE
TM Designworks Chain Guide
One piece "Memory Flex" TM DESIGNWORKS molded plastic housing.
Chain Slide mounts will only be added to swingarms if a slider is purchased or if we receive special instructions to add them from the customer. Since these are custom swingarms chain sliders may need to be shaped with a grinder or file to match the contour of tubing before installation to have the correct placement. Some sliders may not need any modifications on some swingarms. Check yours before modifying. Any sliders for Rectangle tubing will be a wrap-around type slide that fits the rectangle tube better
Extended Rear Braided Brakeline
Extended Rear SS Braided Brakeline When adding an extended Swingarm it is best to add an extended brake line to allow length to safely run your rear brakes. We offer a variety of lengths to choose from.
Terms: Any warranties of product we sell should be taken up with the manufacturer. Prices are subject to change without notice. By submitting your order form you declare that TerraFab and its affiliates are not responsible for any injury, loss, or damage due to the use of its products or services.
BILLET REAR BRAKELINE CLAMP
Chrome Billet Cable-Brake Line clamp that will fit our 1 3/8" diameter swingarms. We also offer 1-1/2" clamps if you already have a swingarm with 1-1/2" tubing. These are made from polished billet aluminum and then chrome plated for that show chrome finish. Cable hole is 3/8" fully closed.